Material Managing Electrical power UNIT 1
Standard Description
This power unit is designed for your fork lift market, consisting of remarkably efficient gear pump, DC motor, guide increase and reduce valve, tank, ect. The up and down motion are controlled by the lever with the manual release valve, that’s equipped with an electric switch to activate the motor. The lowing pace is managed by the stress compensated movement management valve.
Exclusive Notes
1. The duty of this energy unit is S3, i.e. thirty seconds on and 270 senconds off.
2. Clean each of the hydraulic components concerned before installation of the electrical power unit.
3. Viscosity of the hydraulic oil shoud be 15~46 cst, which must also be clean and free of charge of impurities, N46 hydraulic oil is advisable .
4. Oil transforming is required after the first one hundred operation hours, afterwards after each 3000 hours.
five. The energy unit shown is created to be mounted horizontally.

Materials Managing Electrical power UNIT 2
Standard Description
This energy unit features electrical power up gravity down circuit. Activate the start out solenoid to start the motor to lift the machine. The lowing motion is activated through the solenoid valve with the lowering velocity managed through the stress compensated movement manage valve. Merchandise of this series is usually extensively utilized in the sector of logistic units like fork lift, mini lift table, and so forth.
Distinctive Notes
one. The duty of this power unit is S3,i.e.,30 seconds on and 270 senconds off.
two. Clean the many hydraulic components concerned just before mounting the energy unit.
three. Viscosity with the hydraulic oil shoud be 15~46 cst,which should also be clean and free of charge of impurities, N46 hydraulic oil is advised .
four. Oil transforming is needed following the first a hundred operation hours,afterwards after each and every 3000 hours.
5. The power unit ought to be mounted horizontally.