1.A connecting website link of an O-ring Chain for standard application is pre-coated with grease on the pins. Before connection, verify the grease about the surfaces of pins, and should the amount of grease is smaller, apply grease with bare hands. (If gloves are applied, the grease is going to be absorbed by the gloves.)
Illustration: When the connecting hyperlink (I) of an O-ring chain for standard application is
shipped, O-rings are fitted in the roots with the pins. In the event the O-rings come loose on account of vibration during transport, refit the O-rings in to your roots with the pins.
In this instance, you should definitely return the grease collected with the roots in the pins on the central surfaces from the pins, a lot more at portion A than at portions B shown while in the over illustration. (Portions A is worn as a consequence of sliding using the bushings.)
2.The chain could be most quickly linked on the teeth of a sprocket. Engage the back links at both ends on the chain using the sprocket teeth and fit connecting pins. Should the sprocket can be moved, the chain can also be connected on the loosened side.
three. 
Connecting method
one.Confirm that O-rings are connected on the roots of your pins.
2.If the volume of grease applied to the connecting pins is modest, coat the pins with grease at the central portions.
three.Insert the connecting pins to the bushings in the inner back links at the two ends.
4.Confirm the grease is applied to your complete face on the O-ring, and match the O-ring onto the connecting pins.
5.Insert the connecting pins to the connecting plate and while pressing the connecting plate, set up the spring clip. Verify regardless of whether the head (the finish without a split) of your spring clip is turned within the feeding path with the chain. (See the following illustration.)
six.Make sure you confirm the spring clip is securely fitted during the clip grooves from the connecting pins.
This completes jointing on the connecting hyperlink. Note that grease about the surfaces of connecting pins and O-rings can be eliminated in the course of set up work. In this instance, re-grease employing the grease to the surface on the base chain or the grease inside the polyethylene bag by which the connecting hyperlink was contained.
