C Form Flex-Flex Couplings
The C Style coupling includes two flex hubs, one particular sleeve and a single accessory kit consisting of seals and snap rings.
CFR Type Flex-Rigid Couplings
The CFR Type coupling consist of one flex hub, a single rigid hub, one particular sleeve, a single accessory kit consisting of seals and snap rings.
Very simple and inexpensive sort of gear coupling
All steel sleves and hubs
Reinforced rubber seals with snap rings to hold lubricant in area
Available as vertical and horizontal couplings
Wide number of distinctive variations like full-flex, flex-rigid mill motor
Typical configurations can be found from the shelf
Ordering Details
Application: Driver and Driven.
Variety and size of coupling, horizontal, vertical and so on.
Power: Motor horspower or torque necessity.
Velocity: Motor RPM or Driven RPM.
Distance among shaft ends (BSE).
Shaft sizes.
C and CFR Style Couplings
Ordering Info
Puller Holes are standard on sizes 4 through twelve.
Puller Holes are available for sizes 7/8 by means of three.5 at an extra charge.
The BSE (distance Between Shaft Ends) might differ among G and G1.
Interference bores without any set screws are standard unless otherwise specified.
Inch bores and keyway tolerances conform to ANSI / AGMA 9002-B04.
For metric bores and keyway tolerances, seek advice from Engineering Area.
Larger sizes are available, please check with Technical Help.